Table of Contents
Advertisement
1 Lens
2 Camera head
3 Product specifications label
Model names and rated specifications
are labeled.
4 Built-in wire rope
The wire rope is used for fall-
prevention of the camera.
5 BNC cable
Outputs a composite video signal.
Connect to a composite video input
connector of a video monitor, VCR, etc.
6 ALARM OUT indicator (orange)
The indicator lights up in orange when
the alarm output turns on.
Note
The indicator will not light up when pin
11 in qa FUNCTION SWITCH is set to
OFF. For details, see qa FUNCTION
SWITCH.
7 POWER indicator (green)
The indicator lights up in green when
the power is turned on.
Note
The indicator will not light up when pin
12 in qa FUNCTION SWITCH is set to
OFF. For details, see qa FUNCTION
SWITCH.
8 - AC 24 V (power input) terminal
Use the provided 24V AC connector to
connect to the 24 V AC power supply
system.
9 Reset switch
The camera can also be reset to the
factory setting by holding the reset
switch down for 10 seconds with a
needle/paper clip while the power is
turned on.
0 Cable cover
Push down the perforated tab A to
bundle the cables from the side of the
camera.
Location and Function of Part
11
Advertisement
Table of Contents
