Position At Alarm; Load Factory Default - Sony DynaView SSC-CR441 Operating Instructions Manual

Note
When the next event (Alarm Input or
Motion Detection) is detected before the
end of duration time, the camera extends the
time and keeps the state of the alarm out as
a new interval.

POSITION AT ALARM

Each alarm can be configured with 128
preset position, and when alarm INPUT 1 to
4 or MOTION is detected, the camera will
immediately move to the predefined
position. If INPUT or MOTION has been
set to OFF, it would be ignored.
Main menu → :SYSTEM: menu
→ :POSITION AT ALARM: menu
Set POSITION AT ALARM
1
Press "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :SYSTEM:, and then press
the OPEN key to enter the :SYSTEM:
menu.
3
Highlight :POSITION AT ALARM:,
then press the OPEN key to enter the
:POSITION AT ALARM: menu.
46
SYSTEM
4
Highlight alarm INPUT 1 to 4 or
Motion, and configure the calling
preset position after each detection.
5
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.

LOAD FACTORY DEFAULT

Load the Factory Default
This function is used to recover factory
default setting but the TIME of DATE &
TIME item will not change, it stays on
previous setting.
1
Press "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :SYSTEM:, and then press
the OPEN key to enter the :SYSTEM:
menu.
3
Highlight :OTHERS:, and then press
the OPEN key to enter the :OTHERS:
menu.
4
Highlight LOAD FACTORY
DEFAULT, and then press the OPEN
key twice to show the screen:
* LOAD FACTORY DEFAULT
setting is finished
Note
Do not operate the keypad controller while
the LOAD FACTORY DEFAULT message
is blinking and while the next BOOTING
message is blinking. Perform camera
operations after the opening message about
system information is shown.