Preset Setup; Preset Tour - Sony DynaView SSC-CR441 Operating Instructions Manual

PRESET SETUP

Main menu → :PRESET SETUP:
menu
→ :PRESET TOUR: menu
Tips
Before activating the PRESET TOUR
function, refer to the preset commands on
page 55.

PRESET TOUR

Five preset tours (TOUR A/B/C/D/E) are
available in configurations of 16 preset
positions. For convenience of the
predefined preset number controls, the
number below is provided to run each preset
tour temporarily and press "96" and the
PRESET key to stop their action.
TOUR A
Press "70" and the PRESET key to run
TOUR A.
TOUR B
Press "77" and the PRESET key to run
TOUR B.
TOUR C
Press "78" and the PRESET key to run
TOUR C.
38
PRESET SETUP
TOUR D
Press "79" and the PRESET key to run
TOUR D.
TOUR E
Press "80" and the PRESET key to run
TOUR E.
Set the Preset Tour
1
Press "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :PAN TILT SETUP:, and
then press the OPEN key to enter the
:PAN TILT SETUP: menu.
3
Highlight :PRESET TOUR:, and then
press the OPEN key to enter the
:PRESET TOUR: menu.
4
Highlight TOUR SEQUENCE, and
then press the OPEN key to enter.
5
Move the joystick up/down to select
the preset tour for configuration.
6
Move the joystick up/down/left/right
to choose the preset position (P),
move up/down to set the preset point.
It is available for 16 preset position in
random order.
7
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.
The preset tour will start calling the
left position of the 1st line and
continue doing to other right
positions. After end of the line, it will
do the next line also.