Technical Guide | SRG-A40/SRG-A12
3.
Pre-configuration Settings
This chapter describes some pre-configuration settings you will need before activating the SRT
function for the camera.
3.1. Set IP address by using the RM-IP Setup Tool
For IP communication, appropriate IP address needs to be set to the camera. You can use RM-IP
Setup Tool to assign IP address to the camera. Please refer to the RM-IP Setup Tool Guide for more
details.
[Note] DHCP setting cannot be enabled from the RM-IP Setup Tool.
3.2. Setting the initial password
Following the Operation Instruction, initial password setting is necessary to enable HTTP access of
the camera etc..
You can refer to the following section in the Operation Instuction of the camera.
[Accessing the Camera from a Web Browser] > [Setting the Initial Password]
3.3. Camera's Video Codec Setting
For SRT function, the Video Stream 1 channel is only available for SRT streaming. Only [H.264]
can be selected as Codec 1 setting.
Sony
SRT introduction
4
Version 1.0