Fujitsu PRIMERGY RX600 S3 Options Manual page 18

Notes on safety
Components with electrostatic-sensitive devices:
Components with electrostatic-sensitive devices are identified by the following
sticker:
Figure 1: ESD label
When you handle components fitted with ESDs, you must always observe the
following points:
Pull out the power plug before installing or uninstalling components.
You must always discharge static build-up (e.g. by touching a grounded
object) before working with such components.
Any devices or tools that are used must be free of electrostatic charge.
Wear a suitable grounding cable that connects you to the external chassis of
the system unit.
Always hold components with ESDs at the edges or at the points marked
green (touch points).
Do not touch any connectors or conduction paths on an ESD.
Place all the components on a pad which is free of electrostatic charge.
I
For a detailed description of how to handle ESD components, see the
relevant European or international standards (EN 61340-5-1, ANSI/ESD
S20.20).
18 Options Guide RX600 S3
Important notes
U41640-J-Z156-2-76