Main Memory - Fujitsu PRIMERGY RX600 S3 Options Manual

5

Main memory

V
ATTENTION!
Make sure you observe the safety notes in the
on page 13ff.
I
In redundant (mirroring or RAID) configurations, defective memory
boards can be replaced while the system is running ("hot plug"). The
relevant procedure is described in the operating manual supplied with the
server.
This manual describes how to replace memory boards when the system
is switched off.
The system board provides slots for four hot-plug memory boards, each of
which can accommodate up to four memory modules. Two memory modules
("1A/1B" or "2A/2B") make up one memory bank (see
The slots are suitable for DDR II/400 MHz DIMM modules with 1 GB, 2 GB and
4 GB capacity. The board supports a maximum memory configuration of 64GB.
U41640-J-Z156-2-76
Options Guide RX600 S3
chapter "Important notes"
figure 6 on page 26).
25