Fujitsu PRIMERGY RX600 S3 Options Manual page 35

Processors
Installing the heat sink
V
ATTENTION!
Never install a processor without a heat sink, as the processor may
overheat, causing itself and the complete system board to fail.
Ê Carefully place the heat sink onto the processor.
I
Make sure the thermal paste at the bottom of the heat sink is not
damaged.
Figure 17: Fastening the heat sink
Ê Fasten the heat sink with four screws. First fasten two diagonally opposite
screws, then the other two.
U41640-J-Z156-2-76
Options Guide RX600 S3
Installing additional processors
35