Processors
6.2
Replacing the processor
V
ATTENTION!
You may only use processors of the same type on the system board.
Ê Open the server as described in
Ê Remove the processor cover (see
Figure 23: Removing the processor heat sink
Ê Remove the four screws of the heat sink. First undo two diagonally opposite
screws, then the other two.
Ê Turn the heat sink carefully back and forth to loosen it. Then lift it out to
remove it.
Ê Remove the residual thermal paste from the underside of the heat sink.
Ê Clean the underside of the heat sink using a lint-free cloth.
U41640-J-Z156-2-76
chapter "Preparation" on page
page
32).
Options Guide RX600 S3
Replacing the processor
23f.
41