Procedure - Fujitsu PRIMERGY RX600 S3 Options Manual

2

Procedure

V
ATTENTION!
The actions described in this manual should only be performed by
engineers, service personnel or technical specialists.
Equipment repairs should only be performed by qualified staff.
Any failure to observe the guidelines in this manual, and any unautho-
rized opening or improper repairs could endanger the user (through
electric shock, fire hazards) or damage the equipment.
Please note that any unauthorized opening of the device will result in
the invalidation of the warranty and exclusion from all liability.
Ê First of all please familiarize yourself with the safety instructions in the
chapter "Important notes" on page
Ê Make sure that all the manuals you need (see
tation" on page
You will definitely need
– the Operating Manual for the server,
– the Service Supplement for the server and
– the Technical Manual for the system board.
Ê Shut down the server correctly, switch it off, pull out the power plugs, and
open the server as described in the
Ê Extend or upgrade your server as described in the relevant chapter.
I
The installation and removal of the hot-plug components is described
in the operating manual supplied with the server.
Ê Close the server, plug in the power plugs, and switch on the server as
described in the
Ê Start the operating system and, if necessary, configure it as required (see
the Operating Manual).
U41640-J-Z156-2-76
6) are available, printing out the PDF files if necessary.
chapter "Completion" on page
Options Guide RX600 S3
13ff.
"Additional server documen-
chapter "Preparation" on page
69f.
23f.
11