Installing/Removing the Cantilever Arms
NOTE: For this procedure, refer to FIGURE 8.3.
NOTE: Reverse this procedure to remove the cantilever arm.
1. Insert the a flanged bearing into each side of the cantilever arm mounting tube.
2. Put the cantilever arm into place on the back cane mounting bracket.
3. Insert the pivot arm bushing into the cantilever arm mounting tube.
4. Attach the cantilever arm to the back cane mounting bracket with a socket head cap
screw.
5. Adjust the angle of the cantilever arm to accommodate the user. Install the socket head
cap screw through the slot in the cantilever arm mounting bracket and into the hole in
the pivot arm bushing. Tighten the socket head cap screw.
6. Insert the socket head screw into the hole in the back cane mounting bracket. Tighten
the socket head screw.
Socket Head Screw
Back Cane Mounting Bracket
FIGURE 8.3 Installing/Removing the Cantilever Arms
Part No 1143238
Flanged Bearings
Socket Head Screw
45
Cantilever Arm
Cantilever Arm
Mounting Tube
Pivot Arm Bushing
SECTION 8—ARMS
Socket Head Cap Screw
Adjustable ASBA Seat