SECTION 7—POWER ELEVATING LEGRESTS
4. Remove the short shoulder screw and locknut securing the actuator rod to the actuator
bracket.
5. Remove the power elevating legrest actuator from the legrest.
Installing
1. Unscrew the actuator rod ½ turn.
2. Secure the actuator rod to the actuator bracket using the short shoulder screw and
locknut.
3. Secure the top of the power elevating legrest actuator to the power legrest bracket
using the long shoulder screw, flat washer, washer and locknut.
NOTE: The shoulder screw should be on the inside of the legrest and the locknut should be toward
the outside of the legrest.
4. Connect the actuator connector (not shown) to the TRECM or DLIAM connector (not
shown).
5. Install the power elevating legrest. Refer to Installing/Removing the Power Elevating
Legrests on page 34.
Power Legrest Bracket
Long Shoulder
Screw
Flat Washer
Power Elevating Legrest Actuator
Actuator Rod
Short Shoulder Screw
Actuator Bracket
FIGURE 7.10 Removing/Installing the Power Elevating Legrest Actuator
Adjustable ASBA Seat
Inside of
Legrest
Locknut
Washer
Outside of
Legrest
Locknut
42
NOTE: Rear of
right power
elevating legrest
shown. Left
legrest actuator
mounts in the
same way.
Part No 1143238