SECTION 5—CENTER MOUNT FOOTRESTS
Chairs built after 12/01/2008
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
NOTE: For this procedure, refer to FIGURE 5.3.
1. Remove the two mounting screws that secure the button head cleat to the extension
housing.
2. Adjust the footrest extension tube to the desired height.
3. Secure the extension tube to the desired height with the button head cleat and
mounting screws. Securely tighten.
4. Repeat STEPS 1‐3 for the other extension tube.
Button Head Cleat
Mounting Screws
FIGURE 5.3 Adjusting the Height of the Manual Center Mount Footrest -
Adjustable ASBA Seat
WARNING
Extension Tube Mounting Holes
Extension Tube
Chairs built after 12/01/2008
20
Extension
Housing
Part No 1143238