7. Align the two T‐nuts on depth adjustment bracket assembly with channel on legrest.
Slide calf pad assembly to desired height. Tighten the two hex screws securely.
8. Repeat STEPS 1‐6 for opposite side.
Adjusting the Calf Pad Height
NOTE: For this procedure, refer to FIGURE 7.7.
1. Loosen, but DO NOT remove, the two hex head screws that secure depth adjustment
bracket to the T‐nuts.
2. Slide the calf pad assembly with T‐nuts
up or down in the channel to desired
position.
3. Holding the calf pad assembly in
position, tightly secure the hex screws
to the T‐nuts.
4. Repeat STEPS 1‐3 for opposite side if
necessary.
Adjusting the Length for Power Legrest
NOTE: For this procedure, refer to FIGURE 7.8.
1. Loosen, but DO NOT remove, the
button screw (screw also secures lower
end of shroud).
2. Slide footplate with outer cover up or
down to desired position.
3. Securely tighten button screw.
4. Repeat STEPS 1‐3 for remaining legrest.
Part No 1143238
SECTION 7—POWER ELEVATING LEGRESTS
Hex Head
Screws
(T-Nuts
are not
shown)
FIGURE 7.7 Adjusting the Calf Pad Height
Button
Screw
FIGURE 7.8 Adjusting the Length for
Power Legrest
39
Depth
Adjustment
Bracket
Channel
Outer Rail
NOTE: Length
adjustment is
from 15½ ‐ 20
inches.
Outer
Cover
Adjustable ASBA Seat