Installing the Mounting Hardware onto the Contoura Back
1. Secure two of the front mounting brackets to the mounting holes in the Contoura back
using two socket screws, four washers and two locknuts. Torque to 75 in‐lbs ± 20%.
2. Loosely attach the remaining two front mounting brackets to the slots in the Contoura
back using two socket screws, four washers and two locknuts.
NOTE: The two socket screws and locknuts will be tightened when the Contoura back is installed
onto the back canes.
3. Install the Contoura back. Refer to Installing the Contoura Back on page 48.
Contoura Back
Back Cane
Washer
Locknuts
Socket
Screw*
Rear
Mounting
Bracket
Mounting
Screw
Socket
Screw*
Lower Front
Mounting Bracket
FIGURE 9.1 Removing/Installing the Contoura Back
Part No 1143238
Back Cane
Socket
Screws**
Washer
49
SECTION 9—ADULT BACKS
Upper Front
Mounting Bracket
Mounting
Screw
Washer
Mounting Bracket
Washer
*NOTE: Remove these socket screws
when removing the back from the back
canes.
**NOTE: Remove these socket screws
when removing the hardware from the
back.
Socket
Screws*
Lower Front
Adjustable ASBA Seat