Section 6-Front Riggings; Installing/Removing Footrests; Ph904A, Phal4A, 70° And Pw93 - Invacare Adjustable ASBA Seat Service Manual

SECTION 6—FRONT RIGGINGS
SECTION 6—FRONT RIGGINGS
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustments or service, ALWAYS turn the
wheelchair power off, otherwise injury or damage may result.

Installing/Removing Footrests

PH904A, PHAL4A, 70° and PW93
NOTE: For this procedure, refer to
FIGURE 6.1.
1. Turn the footrest to the side (open
footplate is perpendicular to
wheelchair).
2. Install the hinge plates on the footrest
onto the hinge pins on the wheelchair
frame.
3. Push the footrest towards the inside of
the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the
wheelchair when locked in place.
4. Repeat STEPS 1‐3 for other footrest assembly.
5. To remove the footrest, push the footrest release lever inward, rotate footrest outward.
6. Adjust footrest height if desired. Refer to Adjusting the Footrest Height on page 25.
Adjustable ASBA Seat
WARNING
Hinge
Pins
Hinge Plate
Footrest
FIGURE 6.1 Installing/Removing Footrests -
PH904A, PHAL4A, 70° and PW93
24
Footrest Release
Lever
Part No 1143238