Adjusting/Replacing Telescoping Front Rigging Support - Invacare Adjustable ASBA Seat Service Manual

SECTION 6—FRONT RIGGINGS

Adjusting/Replacing Telescoping Front Rigging Support

If the telescoping tubes need to be extended greater than two inches, then the seat
MUST be repositioned rearward to ensure stability - otherwise personal injury and/
or damage to the wheelchair and surrounding property may result.
NOTE: For this procedure, refer to FIGURE 6.8.
1. Remove the two cap screws, spacers and threaded blocks securing the telescoping
front tube to the side rail.
2. Perform one of the following:
• Slide existing telescoping front rigging support to one of six depth positions.
• Remove existing telescoping front rigging.
3. Secure the telescoping front tube to the side rail at the desired depth with the existing
two cap screws, spacers and threaded blocks.
4. Repeat STEPS 1 to 3 on the opposite side if desired.
Side Rail
Cap Screws
FIGURE 6.8 Adjusting/Replacing Telescoping Front Rigging Support
Adjustable ASBA Seat
WARNING
Side Rail
Spacers
28
Spacers
Cap Screws
Threaded
Blocks
Telescoping
Front Tube
Part No 1143238