6. If necessary, adjust powered legs. Refer to Adjusting the Power Elevating Legrests
below.
Removing the Power Elevating Legrests
1. Disconnect power legrests from the harness.
2. Push powered legrest release handle toward the opposite side of the wheelchair and
swing legrest to the outside of the wheelchair.
3. Lift powered legrest and remove from wheelchair.
4. Repeat STEPS 1‐3 for opposite power legrest.
DETAIL "A"
Mounting Pin
Mounting
Hole
Legrest Release
Handle
FIGURE 7.1 Installing/Removing the Power Elevating Legrests
Adjusting the Power Elevating Legrests
Adjusting the Footplate
DO NOT remove heel loops without providing some other adequate means of
support. Otherwise personal injury may occur.
Adjusting the Footplate Height
NOTE: For this procedure, refer to FIGURE 7.2 on page 36.
NOTE: The following procedure should be performed with the user in the wheelchair.
NOTE: T‐nuts ride in the channels of the exterior/interior rails of the power legrests. Refer to
FIGURE 7.2.
1. Loosen, but DO NOT remove, the two interior button screws that secure the footplate
assembly to the T‐nuts.
Part No 1143238
SECTION 7—POWER ELEVATING LEGRESTS
Calf Pad
Jumper
Cable
Footplate
Power
Legrest
Connector
WARNING
35
DETAIL "B"
Adjustable ASBA Seat