SECTION 7—POWER ELEVATING LEGRESTS
Adjusting the Calf Pad
Adjusting the Calf Pad Width
NOTE: For this procedure, refer to FIGURE 7.5.
1. Remove the two button head screws from the calf pad and calf pad bracket.
2. Reposition calf pad to calf pad bracket to desired mounting position.
3. Align button head screws to mounting holes on calf pad and calf pad bracket.
4. Install button head screws into calf pad bracket and calf pad. Securely tighten.
5. Repeat STEPS 1‐4 for opposite side if necessary.
Calf Pad Bracket
Calf Pad
Mounting
Holes
Button
Head
Screws
Adjusting the Calf Pad Depth
NOTE: For this procedure, refer to
FIGURE 7.6.
1. Loosen, but DO NOT remove, hex
screws.
2. Slide calf pad assembly up and out of
the channel.
3. Remove the flat head socket screw, and
locking hex nut that secure the calf
bracket to the depth adjustment
bracket.
4. Reposition the calf bracket on the depth
adjustment bracket to desired position.
5. Install the flat head socket screw
through the calf bracket, depth
adjustment bracket and locking hex
nut.
6. Tighten locking hex nut to screw until snug. DO NOT overtighten nut or calf pad will
not pivot properly.
Adjustable ASBA Seat
Back View
of Legrest
Calf Pad
FIGURE 7.5 Adjusting the Calf Pad Width
38
Mounting
Holes
Flat Head
Socket
Screw
Depth
Locking
Adjustment
Hex
Holes
Nut
Depth
Adjustment
Bracket
Hex
Screws
Calf
Bracket
NOTE: Calf pad not shown for clarity.
FIGURE 7.6 Adjusting the Calf Pad Depth
Calf Pad Bracket
Button
Head
Screws
Channel
Part No 1143238