Rear Arm Socket
Rear Harness Wire Bracket
Hex Screw
2-pin Anderson
Connector (To TRECM
or DLIAM)
Power Elevating Legrest Connector
DETAIL "A" - TIE-WRAP
Tie-wrap
Harness
FIGURE 7.9 Removing/Installing the Power Elevating Legrest Harness
Removing/Installing the Power Elevating Legrest
Actuator
NOTE: For this procedure, refer to FIGURE 7.10 on page 42.
Removing
1. Remove the power elevating legrest from the wheelchair. Refer to Installing/
Removing the Power Elevating Legrests on page 34.
2. Disconnect the actuator connector (not shown) from the TRECM or DLIAM connector
(not shown).
3. Remove the long shoulder screw, flat washer, washer and locknut securing the top of
the power elevating legrest actuator to the power legrest bracket.
Part No 1143238
T-nut
Washer
Tie-Wrap
Harness
(To Legrest)
Rear Harness
Wire Bracket
SECTION 7—POWER ELEVATING LEGRESTS
Locknuts
Front Harness Wire Bracket
Washer
Hex Screw
Cap Screws
DETAIL "B"
Jumper
Cable
Power
Legrest
Connector
41
NOTE: T‐nuts shown
exploded away from
seat frame for clarity.
Seat Frame
T-Nut
Adjustable ASBA Seat