Installing Side Rails; Scala 2 Side Rail; Installing Aria And Bella Side Rail - Invacare Medley Ergo User Manual

7. Guide the Hi/Lo motor cables through the motor pipe
pins.
8. Make sure the pipe pins are properly locked.
9. Place the end of the coiled part of the Hi/Lo motor
cable on the hook at the bed end.
10. Before taking the bed into use, check that all parts run
smoothly and that no motor cables are hanging on the
floor or being squeezed while moving bed sections.
60128481-C

3.7 Installing side rails

WARNING!
Risk of personal damage
There is a risk of entrapment or squeezing, while
assembling or disassembling the side rail.
– Pay attention to your fingers.
– Follow instructions carefully.
– After each assembly, check that all fittings are
properly tightened and that the side rail has
the correct function.
Removable 3/4 length side rails
WARNING!
Risk of entrapment
There's a risk of entrapment or suffocation
between mattress support, side rail and bed end.
– When using removable side rails, always make
sure that the distance between the bed end
and the side rail's handle upper edge is less
than 6 cm in the head end and more than 32
cm in the foot end of the bed.

3.7.1 Scala 2 side rail

Mounting side rail
1.
Place the side rail over the top frame with the release
system A at the head end of the bed.
The fork links on the side rail must be mounted
according to the instruction on the side rail.
2.
Tighten the finger screws B to attach the side rail on
the top frame. Make sure it is steady and fastened.
Dismounting side rail
1. Loosen the two finger screws B and remove the side
rail.

3.7.2 Installing Aria and Bella side rail

WARNING!
Risk of entrapment / suffocation
The user can get trapped or fall out of the bed if
the side rail is not correctly mounted or damaged.
– Make sure that all gliding shoes are correctly
guided into the bed end guideways.
– Make sure that the locking screws are properly
installed at the bottom of the guideways.
Setup
13