Table of Contents
Advertisement
SECTION 3—BED ASSEMBLY
Battery Installation for Emergency Operation
WARNING
Battery is to be used for lowering bed
only.
Battery MUST be replaced after using.
NOTE: For this procedure, refer to
FIGURE 3.3.
1. Install 9V battery into battery mount
location.
2. Connect 9V battery to the connector
lead coming out of the motor.
Installing the Bed Ends
NOTE: For this procedure, refer to FIGURE 3.4.
NOTE: The bed ends are universal and can be mounted to the head or foot end of the bed.
1. Stand one (1) bed end as close to the head spring section as possible.
2. With one hand, grasp the head spring section and raise until the rivets on the corner
plates are at the correct height to fit into the corner locks on the bed end.
DO NOT place your hand between the head spring section and the bed end while
assembling, otherwise injury may occur.
3. Tilt the bed end backward slightly and the rivets should slide into the corner locks
more easily.
4. When the bed end is returned to its full upright position, the bed end will lock into
place.
5. Repeat STEPS 1-4 to install the remaining bed end to the foot spring section.
Bed End
Rivets
Corner Locks
CareGuard™Bed Series
WARNING
Rivets
Head Spring Section
FIGURE 3.4 Installing the Bed Ends
16
Connect 9V
Battery Here
Motor
FIGURE 3.3 Battery Installation for
Emergency Operation
Rivets
Foot Spring Section
Battery Mount
Bed End
Rivets
Corner Locks
Part No 1132730
Advertisement
Table of Contents
