Locknut
Back Cane
Adjusting Spreader Bar Width
NOTE: For this procedure, refer to FIGURE 9.5 on page 54.
NOTE: The spreader bar can be adjusted from 16 to 20 inches or from 20 to 24 inches.
NOTE: This procedure only applies to systems without Contoura backs that omit upholstery.
1. Remove spreader bar. Refer to Removing/Installing the Spreader Bar on page 52.
2. Remove the two screws, four coved spacers and two locknuts securing the two
handles to the tube.
3. Align the handle mounting holes with the desired tube mounting holes.
4. Secure the two handles to the tube using the two screws, four coved spacers and two
locknuts. Torque to 75 in‐lbs ± 20%.
Part No 1143238
Spreader
Bar
FIGURE 9.4 Removing/Installing the Spreader Bar
SECTION 9—ADULT BACKS
Locknut
Mounting
Screw
53
Mounting
Screw
Adjustable ASBA Seat