Installing Adjustable Angle Flip-up Footplate Hinge
NOTE: For this procedure, refer to
FIGURE 6.9.
1. Position footplate hinge on the footrest
support tube at the desired height.
2. Position mounting screw, washers,
spacer, and locknut on the footrest
support as shown.
3. Flip the footplate hinge to the up
position.
NOTE: The footplate hinge will fall to the down
position.
4. Tighten the mounting screw, washer, and locknut that secure the footplate hinge to the
footrest support until the footplate hinge remains in the up position.
5. Check the up and down motion of the footplate hinge to make sure the user of the
wheelchair can operate the footplates easily.
NOTE: If footplateʹs motion is too tight, loosen the mounting screw and locknut approximately ¼‐
turn counterclockwise.
NOTE: If the footplateʹs motion is too loose, tighten mounting screw and locknut approximately
¼‐turn clockwise.
6. Adjust footplate. Refer to Installing Adjustable Angle Flip‐up Footplates on page 29.
Installing Adjustable Angle
Flip-up Footplates
NOTE: For this procedure, refer to
FIGURE 6.10.
1. Slide the half clamp over the footplate
hinge.
2. Hand tighten the two flat screws that
secure the footplate to the half clamp.
3. Adjust the footplates to the necessary
angle and depth for the user. Refer to
Adjusting Adjustable Angle Flip‐Up
Footplates on page 30.
Part No 1143238
SECTION 6—FRONT RIGGINGS
Footplate
Hinge
Locknut
Spacer
FIGURE 6.9 Installing Adjustable Angle
Flip-up Footplate Hinge
90° Footrest Support
Flat Screw
Footplate
Half Clamp
Washer
Locknut
Half Clamp
FIGURE 6.10 Installing Adjustable Angle
Flip-up Footplates
29
Mounting Screw
Washers
Footrest Support
Footplate
Hinge
Nylon
Adjustment
Screw
Footplate Hinge
Adjustable ASBA Seat