Enabling The Mvip Bus Connection - Interphase RAS Communications Controller 5536 User Manual

This dialog box enables you to set up 5536 firmware and
hardware. The board name is displayed in the Cards section.
N
OTE
If the Cards list is empty, the board might not be properly
installed. See
123 for information about correcting the problem.
Use the Cards section to do the following tasks:
• If your board is connected to an MVIP Bus, enable the
• Set up ISDN port properties.
• If you plan to install the Digital Modem RAS Support

Enabling the MVIP Bus Connection

If your board is connected to an MVIP Bus, enable the Bus
connection as follows:
1. In the Cards section of the WAN Adapters Setup dialog
5536 PRI RAS Communications Controller Users Guide
Problems and Possible Solutions on page
MVIP bus connection.
Configure ISDN port properties for both ISDN and
Digital Modem RAS Support drivers.
driver, set up digital modem port properties. Set up
digital modem and ISDN port properties at this point
(regardless of which driver you selected first).
box, select the board and click the Properties button.
Chapter 4: Installing the Software
45