Setting Up Channels As Ras Ports - Interphase RAS Communications Controller 5536 User Manual

Setting Up Channels as RAS Ports

After you respond OK to the message that Remote Access
Service must be invoked, or click Continue to complete the
RAS installation, either the Remote Access Setup dialog box
or the Add RAS Device dialog box appears. This sequence
depends on whether a RAS device is configured in the
machine.
To set up ISDN or digital modem channels as RAS ports, do
the following:
1. If a RAS device has not yet been added, the Add RAS
5536 PRI RAS Communications Controller Users Guide
Device dialog box appears.
If a RAS device has been added, the Remote Access
Setup dialog box appears. Click Add to display the Add
RAS Device dialog box.
The following illustration shows the Add RAS Device
dialog box:
Chapter 4: Installing the Software
53