Setting Up or Removing Channels as RAS Ports
Removing RAS Port Designations
If you need to remove a channel from the RAS device list, do
the following:
1. Access the Remote Access Setup dialog box, as
2. Select the channel in the list on the Remote Access
3. When you have finished removing RAS ports, on the
4. To make the settings take effect, click Close.
5. Continue as follows:
94
described in Steps
Designations on page
Setup dialog box, and click Remove.
Remote Access Setup dialog box, click Continue.
The Network Services dialog box appears.
A message informs you that you must shut down and
restart your computer before the settings take effect.
– If the system is a basic Windows NT system, without
the Windows NT Service Pack installed, click Yes to
restart the computer.
– If the Windows NT Service Pack is installed, click
No. Then reinstall the Service Pack. (Service Pack 3
or higher is recommended.) Restart the system when
prompted after you complete the Service Pack
installation.
1
through
3
of
90.
Setting Up RAS Port
Interphase Corporation