Configuring The Switch Type - Interphase RAS Communications Controller 5536 User Manual

Use the ISDN PRI Port Properties dialog box to view and set
the ISDN port switch type. Also, in Europe, use this dialog box
to select up the CRC type, or, in the US, to set up the CSU
properties. The following topics provide detailed information
about the setup parameters available on this dialog box.

Configuring the Switch Type

To configure the switch type, in the ISDN PRI Port Properties
dialog box, select the appropriate switch type setting from the
SWITCH Type drop-down list.
The following table describes the available switch types:
Select...
ETSI
EUROISDN
NI1 (NT
DMS100 or
AT&T)
AT&T
CUSTOM
NTT
AUSTEL
C
AUTION
Select the same switch type for all ports on a single board.
Otherwise, the ports might not function properly.
5536 PRI RAS Communications Controller Users Guide
Chapter 5: Setting Up WAN Firmware and Hardware
If your telephone company uses...
The ETSI EUROISDN switch type (available in
Europe)
A NORTEL NETWORKS
AT&T (Lucent Technologies ) 5ESS
complies with the National ISDN 1 or National ISDN 2
standard (available in North America)
An AT&T (Lucent Technologies ) 5ESS Custom Point-
to-Point switch or an AT&T (Lucent Technologies )
5ESS Custom switch (available in North America)
NTT switch for (available in Japan)
AUSTEL switch (available in Australia)
®
DMS-100 switch or an
®
system that
81