Setting Up Filters For Incoming Calls - Interphase RAS Communications Controller 5536 User Manual

Setting Up RAS Support Properties
6. Continue as follows:

Setting Up Filters for Incoming Calls

Specify incoming call numbers to be accepted by the ISDN
RAS Support driver by using the Calling number filtering list
on the RAS Support Incoming Filter dialog box. Call filtering
criteria applies to all ISDN RAS ports on the board.
N
OTE
To direct incoming calls to specific ports, use the Call
Setup dialog box. The Call Setup dialog box enables you
to direct calls to specific ISDN and digital modem RAS
ports, as well as Serial driver COM ports. The Call Setup
button on the Incoming Filter dialog box opens the Call
Setup dialog box. For additional information, see
Up Call Properties on page
To access the ISDN RAS Support Incoming Filter dialog box,
do the following:
98
You are prompted to restart the computer.
– If the system is a basic Windows NT system, without
the Windows NT Service Pack installed, click Yes to
restart the computer.
– If the Windows NT Service Pack is installed, click
No. Then reinstall the Service Pack. (Service Pack 3
or higher is recommended.) Restart the system when
prompted after you complete the Service Pack
installation.
101.
Interphase Corporation
Setting