Table of Contents
Advertisement
Hardware Management
Hardware Management
The Cards section of the WAN Adapters Setup dialog box
displays all the 5536 WAN boards installed in the machine,
their status, and their available communication ports. The
Firmware section displays information about the board
selected in the Cards section. You can use the buttons in the
Cards section to add, remove, or configure WAN boards.
N
OTE
If you change any firmware, card, or port properties, you
must apply changes, reload the firmware, save properties,
and restart the system, as described in
Properties on page
The board status is represented by its icon color:
LED Color
Gray
Yellow
Green
Use the following buttons to set up board hardware:
Click...
Add
Remove
76
Meaning
The board is detected but is not working.
The hardware configuration has been changed but not
applied.
The board is running.
To do this...
Add a new board to the operating system. This option is
enabled if one or more Interphase WAN cards can be
installed.
Remove an 5536 board. This option removes the board and
its drivers from the operating system.
87.
Saving WAN Setup
Interphase Corporation
Advertisement
Table of Contents
