Table of Contents
Advertisement
Setting Up Card and Port Properties
4. If the board has dual ISDN ports, repeat Steps
Next, continue to
if you are (or will be) installing the Digital Modem RAS
Support driver.
If you do not plan to install the Digital Modem RAS Support
driver, or have already configured digital modem port
properties, go to
Configuring Digital Modem Port Properties
If you are installing the Digital Modem RAS Support driver,
configure corresponding digital modem port properties as
follows:
1. In the Cards section of the WAN Adapters Setup dialog
Figure 4-9. Digital Modems Properties Dialog Box
2. Use this dialog box configure the analog-to-digital
48
3
to configure the remaining ISDN PRI port.
Configuring Digital Modem Port Properties
Completing the WAN Setup on page
box, select the digital modem port (x Digital Modems,
where x is the number of digital modems on the board),
and click Properties.
The Digital Modems Properties dialog box appears:
speech channels coding law according to the geographic
region.
– For Europe and Australia, select A Law.
1
through
49.
Interphase Corporation
Advertisement
Table of Contents
