3. Click OK.
If you have not yet configured the board's ISDN port
properties, do so now, as described in
Properties on page
Completing the WAN Setup
When WAN card and port properties are configured as needed,
do the following to complete the WAN setup:
1. Click OK in the WAN Adapters Setup dialog box.
2. When the following message informs you that the driver
Figure 4-10. Successful Setup Message
Next, set up RAS support properties for the driver.
5536 PRI RAS Communications Controller Users Guide
– For North America and Japan, select
Law).
46. Otherwise, continue to the next topic.
The setup software finds firmware for the board. It
updates the registry and dynamically installs the drivers.
is running, click OK.
Chapter 4: Installing the Software
µ
Configuring ISDN Port
Law (Mu
49