Setting Up Digital Modem Port Properties - Interphase RAS Communications Controller 5536 User Manual

Option
Facility Data
Link Protocol(s)

Setting Up Digital Modem Port Properties

If the 5536 Digital Modem RAS Support driver is installed on
the machine, you can use the WAN Adapters Setup Utility to
change the board's digital modem port properties. These
properties identify the speech coding law to use with modems
in your geographic location.
To set up digital modem port properties:
1. Select the digital modem port (x Digital Modems
5536 PRI RAS Communications Controller Users Guide
Chapter 5: Setting Up WAN Firmware and Hardware
Description
Facility Data Link protocols are used to exchange
messages between the board and the remote end of the
network. These messages are issued by the Telco to put
the board in loopback mode for testing when problems
occur. They are also used to transmit statistics about
physical transmission errors on the line.
Two protocols are available for the facility data link:
ANSI-T1-403 and ATT-54016. They are compatible
with each other.
Use the protocol(s) indicated by your Telco. If this
information is unavailable, select both protocols.
where x is the number of modems on the board) in the
85