Understanding LoopTest Messages
Understanding LoopTest Messages
The Diagnostic field in the main LoopTest dialog displays
LoopTest test results:
The following table describes diagnostic messages:
Message
Test passed
Card missing or
non-ISDN
158
Figure C-3. LoopTest Test Results
Cause
LoopTest detected no errors during testing.
An error occurred before accessing the network.
Possible causes are:
• The card is not installed.
• The drivers are not properly installed.
• LoopTest could not find an ISDN port on the card.
To check for ISDN ports:
a. From the Start menu, select Programs, then
Interphase WAN Adapters, and then WAN
Setup.
b. Make sure the firmware contains the ISDN layer.
Interphase Corporation