Connecting To The Network; Chapter 4 Installing The Software - Interphase RAS Communications Controller 5536 User Manual

Connecting to the Network

W
ARNING
Before connecting the cable, read
Unsafe Voltages
front of this manual.
With the board installed, you are ready to connect to the
network, as follows:
1. Obtain the cable required for your type of connection, as
2. Attach the appropriate RJ48C-compliant connector to
3. Reconnect the power cable and turn on the machine.
After connecting to the network, install the drivers. See
Installing the Software on page
5536 PRI RAS Communications Controller Users Guide
in the
described in T1 Link Requirements on page 31
E1/PRI Cabling Requirements on page
the board.
Chapter 3: Connecting to the Line
Telephone Lines
Safety Precautions
37.
section at the
or
32.
35