Minimum System Requirements - Interphase RAS Communications Controller 5536 User Manual

Minimum System Requirements

• If the ACE/Server grants the access, the communication
• If the ACE/Server refuses the access, the
The RAS support driver can manage secured multilink
connections as well. The SecurID authentication is processed
only for the primary link.
All the SecurID authentication successes or failures are
registered in the Windows NT Event log.
Minimum System Requirements
Following are the minimum system requirements for using this
board with Microsoft Remote Access Service (RAS):
• Intel
• PCI Bus architecture conforming to PCI Local Bus
• Pentium processor at 133 MHz or faster
• 64 MB RAM (possibly 128 MB or more, depending on
• Hard disk with 6 MB free
• CD-ROM drive
• Single PRI version: One functional ISDN primary rate
• Dual PRI version: One or two functional ISDN primary
12
can continue with the Windows NT authentication
phase.
communication is immediately broken. When the
connection is untrusted because of the passcode end-of-
delay, the remote client is not especially notified: the
failure is a connection failure. It is the client's
responsibility to start the connection again.
®
system running Windows NT Version 4.0
Specification Revision 2.1
your RAS configuration and usage)
interface for each board
rate interfaces for each board
Interphase Corporation