Table of Contents
Advertisement
6.0
CLI Commands
To use the CLI commands, enter enable once you have logged into the switch.
The following table lists the Command level of the CLI commands.
Command
Description
User EXEC
This command is a subset of
the commands available at
the privileged level.
this command to:
Privileged
The privileged command is in
EXEC
advanced mode.
command to:
Global
Use
configuration
configure parameters that
will apply to the switch as a
whole
VLAN
Use
database
configure
parameters
Interface
Use this mode to configure
configuration
parameters
Waters Network Systems
Perform basic tests
Display
information
Use this
Display advanced status
functions
Save configuration
this
command
this
command
VLAN
specific
MS1008-2G-4POE/PSX1008-2G-4PoE User's Manual
Prompt Access
switch>
Use
system
switch#
to
switch
(config)
#
to
switch
(vlan)#
switch
(config-i
Exit
Method
Method
Begin a
Logout or
session with
quit
the switch
Enter the
Disable
enable
command
while in EXEC
mode.
Enable takes
you into the
privileged
mode.
Enter the
Exit or
configure
end
command
while in
privileged
mode
Enter the
Exit
VLAN
database
command
while in
privileged
EXEC mode
Enter the
Exit
interface
Page 73
Advertisement
Table of Contents
