Table of Contents
Advertisement
5.17
Port Control Menu
The section of this screen is used to configure each port. The bottom section displays
the current settings for each port.
Port - Select the port that you want to configure.
State - Current port status. The port can be set to disable or enable mode. If a port is
set to disable, it will not be able to receive or transmit packets.
Negotiation - Set auto negotiation status of the port. There are two choices, auto
and force. If you set negotiation to force, the following settings must be made:
• Speed – Hard set the speed to either 10 or 100 for ports 1-8. The Gigabit ports
can be set at either 10, 100 or 1000.
• Duplex – Choose between full-duplex or half-duplex.
Flow Control – The default for flow control is Disable. Flow control is Symmetric or
Asymmetric in Full Duplex mode.
Security – The default for security is Off. When turned On, the port will accept only
one MAC address.
Click Apply to save the configuration.
Waters Network Systems
Figure 5.17 – Port Control
MS1008-2G-4POE/PSX1008-2G-4PoE User's Manual
Page 39
Advertisement
Table of Contents
