Cli Commands - Waters Network Systems GSM2109 Operating Manual

4.2

CLI Commands

To use the CLI commands, enter enable once you have logged into the switch.
The following table lists the Command level of the CLI commands.
Command Description
User EXEC This command is a subset of
the commands available at
the privileged level.
this command to:
Privileged The privileged command is in
EXEC advanced mode.
command to:
Global Use
configuration configure parameters that
will apply to the switch as a
whole
VLAN Use
database configure
parameters
Interface Use this mode to configure
configuration parameters
Waters Network Systems
Perform basic tests
Display system
information
Use this
Display advanced status
functions
Save configuration
this command
this command
VLAN specific
GSM2109/GSM1009-SFP User's Manual
Prompt Access
Method
switch> Begin a
session with
Use the switch
switch# Enter the
enable
command
while in EXEC
mode.
Enable takes
you into the
privileged
mode.
to switch Enter the
(config) configure
# command
while in
privileged
mode
to switch Enter the
(vlan)# VLAN
database
command
while in
privileged
EXEC mode
switch Enter the
(config-i interface
Exit
Method
Logout or
quit
Disable
Exit or
end
Exit
Exit
Page 19