Port Control - Waters Network Systems GSM2109-1009-8PoE Operating Manual

oversize, CRC align errors, fragments and jabber packets)
TX Abort Packet - counts the aborted packet during transmission
Packet Collision – counts the dropped packets
TX Bcast Packet – counts the broadcasted packets
Rx Mcast Packet – counts the multicast packets
The clear button will clean out all counts.
5.17

Port Control

The section of this screen is used to configure each port. The bottom section displays
the current settings for each port.
Port - Select the port that you want to configure.
State - Current port status. The port can be set to disable or enable mode. If a port is
set to disable, it will not be able to receive or transmit packets.
Negotiation - Set auto negotiation status of the port. There are two choices, auto
and force. If you set negotiation to force, the speed and duplex modes must be set
manually.
• Speed – Available when negotiation is set to Force.
• Duplex – Available when negotiation is set to Force .
Flow Control – Flow control is set to Enable or Disable. When enabled, once the
Waters Network Systems
Figure 5.16 – Port Statistics
GSM2109-1009-8PoE User's Manual Page 43