Installing The Top Cover - Intel SRPL8 Product Manual

Installing the Top Cover

1. Observe the safety precautions, warnings, and cautions at the beginning of this chapter.
2. Install the 240 VA protective cover.
3. While facing the back of the server, position the top cover over the chassis so that the tabs
along the edges of the cover align with the slots in the top edge of the chassis.
4. Gently lower the cover straight down on top of the server.
5. Place your hands on opposite sides of the cover, then push the cover forward to seat it.
6. Attach the cover to the chassis with the screws you removed earlier, and tighten them firmly
(6.0 inch-pounds).
7. Connect all external cables and power cords to the server.
SRPL8 Server System Product Guide
Figure 24. Removing the 240 VA Protective Cover
OM11029
99