Table of Contents
Advertisement
Installing a SCSI SCA Hard Disk Drive in a Hot-Swapping Bay
See Figure 18.
1. Orient the carrier and drive assembly in front of the hot-swapping bay guide rails so that metal
fingers of the perforated metal bracket attached to the carrier are facing up. Make sure that the
carrier is placed correctly into the guide rails to avoid damage.
2. While grasping only the drive carrier handle, firmly push the assembly into the bay until the
drive docks with the hot-swapping backplane connector.
CAUTION
Do not press on the perforated metal bracket of the carrier when you push
the assembly into the bay, or you can damage the metal fingers of the
bracket.
3. If you installed a RAID controller board, run the Disk Array Controller Configuration utility
supplied with the board. See the manufacture's documentation provided.
86
A
Figure 18. Installing a Hard Disk Drive
A.
Drive carrier latch
Hot-Swapping Fans, SCSI Hard Drives, and Power Supplies
OM07527
Advertisement
Table of Contents
