Installing The Peripheral Bay Blind Mate Board - Intel SRPL8 Product Manual

Installing the Peripheral Bay Blind Mate Board

See Figure 38.
1. Remove the board from its protective wrapper.
2. Position the board against its support in the chassis, then attach it with the four screws you
removed earlier.
3. Connect all previously removed cables to the board.
4. Install the peripheral bay (see "Installing the Peripheral Bay").
5. Install the profusion carrier tray (see "Installing the Profusion Carrier Tray" on page 104).
SRPL8 Server System Product Guide
B C
Figure 39. Peripheral Bay Blind Mate Board Cables
A. Blind Mate connector header
B. 20-pin power connector
C. Wide SCSI connector
D. 40-pin IDE connector
E. 34-pin header (floppy)
A
D E
OM10708
123