Table of Contents
Advertisement
Serial Line: When the line selection is set to direct connect (serial line), you must specify the
following.
Baud Rate: Specifies baud rate; must be 19200 for DPC to connect properly.
COM Port No.: Sets the COM port number to which the null modem serial cable is
connected.
Connect: Initiates connection to the server. When you click this button, you are prompted for
the EMP password.
Config: Displays the Phonebook dialog.
Cancel: Exit the Connect dialog with no action taken.
Help: Display dialog-level help information.
Powering the Server On/Off Remotely
Select Power On/Off from the Action Menu to power the server on or off, with post-power-up
options. This option generates the Power on/off dialog.
Options available in the dialog are:
Power ON: Powers on the server.
Power OFF: Powers off the server. This option is not allowed if the server is configured in
restricted mode for EMP operations.
Post-power-up option: Sets the server mode to EMP active or BIOS redirection. The setting
is effective at the next power-up. The default selection is EMP active.
Cancel: Exits the dialog with no action taken.
Help: Displays dialog-level help information.
SRPL8 Server System Product Guide
Figure 12. Power On/Off Dialog
69
Advertisement
Table of Contents
