Equipment Required For Crb Usage; Precautions - Intel 6300ESB ICH User Manual

Equipment Required for CRB Usage

The following components are required for the Intel
Bus and Intel
•
A 550 W SSI EPS 12 V power supply. The CRB is shipped with the power supply.
•
At least two modules of DDR2 400 DIMM. The CRB is shipped with 2 x 256 Mbytes of
DDR2 400.
•
Hard drive loaded with Operating System
•
Monitor
•
PS/2 mouse and keyboard
Visually inspect the board and ensure that the MCH, Intel
other components did not shake loose during shipment. If the board has any loose or missing
components, contact your Intel representative.
Caution: Powering up without all components installed correctly could lead to a power-up failure that could
damage the board. Do not power up the board until the source of any loose component is
determined and the component has been replaced on the board.
3.1

Precautions

The following precautions will reduce the chances of damaging the board:
•
Ensure that a 550 W SSI EPV 12 V power supply is used to power up the CRB. Refer to
Section 5.1, "Power Diagrams" on page 25
CRB.
•
This platform supports DDR2 400 DIMMs; ensure that the same speed DIMM is plugged in
all slots of the platform.
•
Ensure that each processor has heat sinks attached before powering up the board.
•
Ensure that the heat sink is attached to the MCH and PXH before powering up the board.
Never attach a heat sink while the board is powered.
•
Use Table 4
1. Note The hard disk provided with the development kit is not pre-loaded with any software.
®
Intel Xeon™ Processor, Intel
® ®
E7520 and Intel 6300ESB Customer Reference Board (CRB) usage:
to verify that all jumpers are in their default positions.
®
E7520 Chipset, Intel
Equipment Required for CRB Usage
®
Xeon™ Processor with 800 MHz System
1
®
6300ESB I/O Controller, PXH, and
for details on the SSI power supply interface on the
®
6300ESB ICH Development Kit User's Manual
3
17