Equipment You Will Need; Changing The Fuse And Voltage Selector - Intel SYSTEM 310 Hardware Integration Manual

Installing and Removing Parts
System 310
Equipment You Will Need
A pair of needle-nosed pliers.
Steps
The AC line filter, where you plug in the power cord, also houses the
fuse and voltage selector board. Figure 5-1 shows the location of
these parts. Since you must remove the fuse to change the voltage
selection, the six steps in this section explain how to perform both
tasks.
Specifically, steps 1, 2, 3, and 6 refer to changing the fuse. Steps 4
and 5, which explain how to choose a different voltage setting, are
inserted into the fuse-changing instructions at the appropriate point.
If you want to change the fuse and the voltage selection, follow all
six steps in order. The entire process takes about 10 minutes.
Figure 5-1. Changing the Fuse and Voltage Selector poias
5-2