Yamaha CE50T Service Manual page 26

4. Close the throttle grip completely.
5. Check:
®Autolube pump pulley position (_
Out of position-*Adjust.
_ Autolube Pump Pulley Position
®:
0.0-1.0 mm (0.0-0.04 in)
Autolube pump pulley position adjustment
steps:
oLoosen the Iocknut _.
®Turnthe adjuster (_ in or out until the pump
plunger pin (_ is aligned with the mark _)
on the pump pully.
eTighten the Iocknut.
6. Install:
oAutolube pump cover
oFootrest board
®Front panel
• Front fender
eTail cover
Refer to "FRONT FENDER, FRONT PANEL
AND FOOTREST BOARD" and "TAIL
COVER" section.
AUTOLUBE PUMP AIR BLEEDING
The Autolube pump and delivery lines must be
bled on the following occasions:
•,Whenever the Autolube tank has run dry.
oWhenever any portion of the Autolube
system is disconnected.
oIf the scooter lies on its side after falling over.
2-9