Assembly; Installation - Yamaha CE50T Service Manual

CA.BO. TO. CA"B 4]
®Measure the distance between the mating sur-
face of the float chamber (gasket removed)
and top of the float using a gauge.
NOTE:
_ The float arm should be resting on the needle
....... "J valve, but not compressing the needle valve.
e If the float height is not within specification,
.:::ii_ _ . ......... i!_ _: inspect the needle valve, float and ralve seat.
i;_;:;, _i;::_::!_::;:_i::.i -If it is worn, replace it.
NOTE:
The float height is properly adjusted at the
Yamaha factory. Never attempt to adjust it.
ASSEMBLY
To assemble the carburetor, reverse the dis-
assembly procedures. Note the following points.
®Before reassembling, wash all parts in clean
gasoline.
=Always use a new gasket.
1. Install:
®Throttle valve (_)
NOTE:
Align the groove (_) of the throttle valve with the
projection (_ of the carburetor body.
I NSTA LLATI O N
1. Install:
• Carburetor assembly
Reserve the removal procedure.
4-10