Ink Error - DataCard SR200 Service Manual

(6) Press [RESET] →
5.1.8 MG Test Err
MG writing error occurred during MG self-diagnosis.
Reset the printer.
MG Test Err

5.1.9 Ink Error

An incorrect printer ink is installed. Attach a correct ink.
Ink Error
1-28 (No.HD007<Rev.001>)
to initialize the printer.
A8
B0
5.1.10 Ink Serch
Ink ribbon is broken. Repair it.
Ink Serch
Note:
• Stand the cassette on a flat surface as illustrated in the dia-
gram.
Avoid doing so on a floor as dust attached to the ink ribbon
may cause printing errors.
• Do not touch the inked surface (the side that faces outward
when installed) with your hand. Touching it may cause print-
ing errors. Put on the supplied gloves when handling the ink
ribbon.
• When handling the cassette, hold it with both hands.
Accidentally dropping the cassette may damage it or result
in injuries.
• When installing a used ink ribbon, align the yellow side of the
unused ribbon with the arrow indicated on the label of the
cassette.
If the position of the yellow side is not properly aligned, the
print may turn out light.
• Do not perform work on the printer door. Do not place heavy
objects or apply load on the printer. Doing so may damage it.
• During replacement, clean the four bobbin holders on the
printer.
Burrs generated by friction between the bobbins and bobbin
holders may be adhered to the ink ribbon or retransfer film,
causing printing errors.
(1) Open the printer door.
(2) Press and hold down the cassette button, and pull out
the cassette (on the right) to remove the ink ribbon.
(3) Cut away the broken portion, and attach the unused por-
tion at the supply side to the other end at the take-up side
using an adhesive tape.
B1