DataCard SR200 Service Manual page 26

b) The cover of the card hopper is opened. When the
card can be removed, it removes.
(3) The turnover part is rotated a little right and left by using the
jog dial.
Note:
When the card has gone out of the turnover part, the
turnover part cannot be rotated.
The turnover part and the cleaning unit are rotated in a
right and left, opposite direction at the same time, and
the card is moved to the turnover part.
(4) The turnover part and the cleaning unit are rotated in a right
and left, opposite direction at the same time, and the card
is moved to the turnover part.
(5) Close the printer door, and press [RESET] →
tialize the printer.
• The card is discharged from the NG card outlet or card
stacker.
5.1.4 Jam (MG)
Card jam in the magnetic encoder unit. Remove the jammed
card.
Jam (MG)
(1) Open the printer door.
(2) Restore the card to the magnetic encoder unit.
Use the jog dial to turn the cleaning unit.
(3) Turn the jog dial at the turnover unit to adjust the unit to a
vertical position.
While doing so, make use of the printer's label as a refer-
ence.
(4) Move the card to the center of the turnover unit
• Maintain the turnover unit in the vertical position.
• Turn the jog dial at the cleaning unit.
Check to ensure that the card moves to the turnover unit.
(5) Turn the jog dial attached to the turnover and cleaning units
at the same time in opposite directions.
• Set the turnover unit to the horizontal position.
(6) Turn the jog dial of the turnover unit clockwise to an angle
of 45 degrees.
• While doing so, make use of the printer's label as a ref-
erence.
(7) Turn the jog dial at the cleaning unit in the anti-clockwise
direction.
• The card is discharged from the NG card outlet.
to ini-
92
(No.HD007<Rev.001>)1-25