DataCard SR200 Service Manual page 28

5.1.7 Film Serch
Retransfer film is broken. Repair it.
Film Serch
Note:
• Stand the cassette on a flat surface as illustrated in the dia-
gram.
Avoid doing so on a floor as dust attached to the retransfer
film may cause printing errors.
• Do not touch the inked surface (the side that faces outward
when installed) with your hand. Touching it may cause print-
ing errors. Put on the supplied gloves when handling the
retransfer film.
• When handling the cassette, hold it with both hands.
Accidentally dropping the cassette may damage it or result
in injuries.
• When installing a used retransfer film, align the unused side
of the film with the arrow indicated on the label of the cas-
sette.
Failure to do so may result in errors, or the print may turn out
light.
• Do not perform work on the printer door. Do not place heavy
objects or apply load on the printer. Doing so may damage it.
• During replacement, clean the four bobbin holders on the
printer.
Burrs generated by friction between the bobbins and bobbin
holders may be adhered to the ink ribbon or retransfer film,
causing printing errors.
(1) Open the printer door.
(2) Press and hold down the cassette button, and pull out
the cassette (on the left) to remove the retransfer film.
(3) Cut away the broken portion, and attach the unused por-
A1
(4) Attach the retransfer film, and turn the take-up side until
(5) Insert the cassette all the way in along the guide rail until
tion at the supply side to the other end at the take-up side
using an adhesive tape.
the cut section is out of sight.
a) With the retransfer face facing outward, align the
unused side of the film with the arrow on the cas-
sette, and unwind it along the three shafts.
b) Insert the retransfer film firmly into the bobbin hold-
ers with the film set to the far end of the guides.
c) Turn the knob in the direction of the arrow to re-
move any slack.
a "click" sound is heard. Close the door.
(No.HD007<Rev.001>)1-27